Walkera QR X350 Pro Motor Adapter Set

Each of our Walkera QR X350 Pro Motor Adapters are CNC machined from billet aluminum.  These motor adapters will allow the use of the common 2212 and 28mm sized brushless outrunner motors to be installed into the stock frame. 

Now you can experiment with your favorite aftermarket motors on this great quad.  Plus run a large variety of aftermarket props to get the best performance possible from your QR X350.

The adapters are very strong and light weight.  They also act as a heat sink to help keep the motors running cooler.

Installation is quick and simple.  Only modification necessary is to slightly trim some plastic on the inside of the top cover.  This will allow for a bit more clearance at the base of the new motor where the wires exit.  Modification may not be necessary depending on which motor you use.   This is shown in one of our photos.

Two step installation:

1. Install new motor adapter to the back of your new motor with supplied M3x6 flat head screws.
   (Out motor adapters have slightly offset holes for mounting to the frame)
   (Be sure to orient adapter onto motor so wires line up with frame)
    
2. Install adapter / motor assembly onto the frame with the supplied M3x4 socket head screws.
    

Included:  4 - Walkera QR X350 Pro Motor Adapters
                16 - M3 x 4mm socket head screws (for mounts)
                16 - M3 x 6mm flat head screws (for motors)

Weight (single motor adapter only):  2.8g
 

Notes: PLEASE READ FOR IMPORTANT INFORMATION TO HELP PROTECT ELECTRONICS

-  When installing a new motor, it will be up to the end user to verify that the motor and prop combination do not exceed the maximum allowable amperage draw for the stock ESC.

-  Since these adapters can allow for a very large variety of motors to be installed, we can not be held liable for any damages that may occur from drawing to much power from the stock ESC (electronic speed control).

-  Be sure when installing new motors and before flying, all motors are spinning in the direction indicated on the QR X350 Pro frame.

Compatible Motors

• 28mm Brushless Outrunners
• 2212 sized Brushless Outrunners
   

Acceptable bolt patterns (units in mm):

• 16x16
• 16x19
• 19x19

Please contact us with any questions

Write a review