E-Flite Apprentice 15e / S 15e 3548 Aluminum Motor Mount
Availability: Out Of Stock
 |
 |
 |
 |
 |
 |
The Apprentice 15e / S 15e 3548 series aluminum motor mount is CNC machined from billet aluminum. A key feature of this mount is that it utilizes the stock plastic mount as a buffer zone in the event of a crash. The inexpensive and easily replaceable stock plastic mount should take the impact instead of damaging the planes fuselage.
This mount will allow you to run a large selection of aftermarket motors. No cowl modifications are necessary, simply bolt on and you are ready to fly.
Three step installation:
- Attach new motor to aluminum mount with the motors supplied screws
- Attach E-Flite stock plastic mount using the original motor screws
- Attach entire assembly to the planes fuselage with the original mounting screws
Included: 1 - Apprentice 15e Aluminum Motor Mount with Propeller bushing
Weight: 7.9g
Notes:
If using the stock propeller with the bolt on propeller shaft, you will need to use the supplied propeller bushing. Simply press the bushing into the propeller hub and install onto the motor shaft.
Center of Gravity should always be checked and adjusted per the user manual after installation of a new motor.
Compatible Motors
There is a large selection of motors to choose from. Here are a few options.
- Turnigy Aerodrive SK3 3548 1050KV, or 840KV
- Heads Up RC 3548-09
- NTM Prop Drive 35-48 900KV (accessory pack required)
- Others in the 3548 series with bolt patterns shown below
Acceptable bolt patterns (units in mm):
- 19x19
- 19x25
- 25x25
Please contact us with any questions on motor compatibility