Zeta FX-79 Buffalo Aluminum Motor Mount
Availability: In Stock
| |
 |
Our FX-79 Buffalo Aluminum Motor Mount is CNC machined from billet aluminum. It is designed to adapt a large range of 35mm outrunner motors to the Zeta FX-79 Buffalo FPV Flying Wing models.
This FX-79 aluminum motor mount is much stronger than the stock plastic one and will eliminate the common cracking and breaking issues during landing.
Our mount is also 10mm longer than the stock one. This will allow for more prop clearance when running aftermarket motors with bolt on prop adapters.
These are a direct replacement with no modifications necessary.
Two step installation:
-
Install aluminum motor mount into bottom half of fuselage using a good 5min. epoxy or similar.
a. Rotate mount to desired position for mounting motor and running wires.
b. Glue top half of motor cover onto motor mount. -
Install motor to new mount with supplied motor screws.
Included: (1) FX-79 Buffalo Aluminum Motor Mount, (4) M3 x 6 Motor Screws
Weight: 22g
Notes:
- When installing motor mount use a good 5min epoxy or similar. Make sure to rotate face of mount to desired position for mounting motor and running wires.
- Stock motor and prop combination can be used.
Compatible Motors
- 28mm Outrunners
- 35mm Outrunners
Due to the large variety of compatible motors please verify motor size and KV will suite flying style
Acceptable bolt patterns (units in mm):
- 16x16
- 16x19
- 19x19
- 19x25
- 25x25
Please contact us with any questions on motor compatibility