Universal Pusher Adjustable Motor Mount 28 / 35mm Outrunner
Availability: In Stock
| |
 |
 |
This two piece mount is CNC machined from billet aluminum. It is designed to adapt a large range of 28mm and 35mm diameter outrunner motors to your pusher style plane. It will allow for the motor to be mounted up to 1" higher than the stock position allowing for up to a 2" large diameter propeller.
With this feature you can easily run a lower KV motor with a larger propeller for more thrust and better efficiency. This would be a perfect combination for FPV pilots looking for longer flight times and a more quiet platform.
Swapping motors can easily be done by removing a few screws. This is ideal for those looking to achieve the best performance possible.
Three step installation:
- Attach motor mount base to the plane with supplied flat head screws, washers, and locking nuts.
- Attach new motor to motor plate with supplied flat head screws.
- Attach motor plate to motor base with suppled pan head screws.
Included: 1 - AP 16x25 Motor Mount Set
Total Weight: 14g (not including mounting hardware)
Notes:
A 35mm outrunner will only fit in the top position. A 28mm outrunner will work in the two lower positions. If a change in thrust angle is needed, simply add a small washer between the motor base and motor plate at the appropriate locations.
Center of Gravity should always be checked and adjusted per the user manual after installation of a new motor.
Compatible Motors
- 35mm Outrunners
- 28mm Outrunners
Due to the large variety of compatible motors Please verify motor size and KV will suite flying style
Acceptable bolt patterns (units in mm):
- 16x16
- 16x19
- 19x19
- 19x25
- 25x25
Please contact us with any questions on motor compatibility