Blitz RC Works Super Sky Surfer Adjustable Motor Mount

This two piece mount is CNC machined from billet aluminum.  It is designed to adapt a large range of 35mm and 42mm diameter outrunner motors to the Blitz RC Works Super Sky Surfer. It will allow for four different motor mounting heights to accommodate propeller sizes up to 13" in diameter.

With this feature you can easily run a lower KV motor with a larger propeller for more thrust and better efficiency. This would be a perfect combination for FPV pilots looking for longer flight times and a more quiet platform.

Swapping motors from a 35mm outrunner with an 8" prop to a 42mm outrunner with a 13" prop can easily be done by removing a few screws.  There are a large number of motor / propeller combinations possible with this setup.  This is ideal for those looking to achieve the best performance possible.

Position 1: stock height up to a 10" prop.
Position 2: (+) 0.47" for up to an 11" prop.
Position 3: (+) .95" for up to a 12" prop.
Position 4: (+) 1.42" for up to a 13" prop.

Three step installation:

1. Glue motor base tube into the fuselage (nacelle) making sure mounting flange is square.
2. Attach new motor to motor plate with supplied flat head screws.
3. Attach motor plate to motor tube at desired height with suppled pan head screws.

Included: 1 - SSS Base Tube and SSS Motor Plate, 4 motor screws and 4 mount screws.

Total Weight: 35g

Notes:

The stock thrust angles are retained in all 4 positions. If a change in thrust angle is desired, simply add a small washer between the motor base and motor plate at the appropriate locations.

Dimensions: I.D. = 1.5" (38mm)  / O.D. = 1.6" (40.6mm)  / Length: 1.37" (34.8mm)

Center of Gravity should always be checked and adjusted per the user manual after installation of a new motor.

Click here for the original Blitz RC Works Sky Surfer Adjustable Motor Mount.

Compatible Motors

• 35mm Outrunners
• 42mm Outrunners

Due to the large variety of compatible motors Please verify motor size and KV will suite flying style

Acceptable bolt patterns (units in mm):

• 19x19
• 19x25
• 25x25
• 25x30
• 30x30

Please contact us with any questions on motor compatibility

Write a review