E-Flite Blade 350 QX / QX2 / QX3 Prop Adapter and Spinner Nut Set
Availability: Out Of Stock
Each of our E-Flite Blade 350 QX / 350 QX2 / 350 QX3 propeller adapters and spinner nuts are CNC machined from billet aluminum. These adapters will bolt on to the stock BLH7802 motors allowing for a large variety of aftermarket propellers to be used.
They have a 6mm propeller shaft which can be used with the traditional style quadcopter propeller sets. The spinner nuts make it quick and easy to attach the propellers giving a nice finished look.
The adapters and spinner nuts are very strong and light. This design keeps the propeller very close to the motor to maintain stock flying characteristics. Replacing the stock propellers with a good quality aftermarket propeller will give you the confidence needed for worry free flying.
This set includes 2 right hand thread adapters / spinner nuts and 2 left hand thread adapters / spinner nuts. Each propeller will be self tightening while the motor is powered.
Installation is quick and simple. No modifications necessary.
Two step installation:
-
Install prop adapter onto stock BLH7802 motor using the supplied M2.5 x 4mm socket head screws.
(each bag will be labeled indicating which motor the adapters should be installed on)
(see diagram below for more detailed info on prop adapter placement)
-
Install propeller onto adapter followed by the spinner nuts and tighten with a small allen wrench or screwdriver inserted through the hole.
Included: 4 - E-Flite Blade 350 QX / QX2 / QX3 Prop Adapters (2 right hand thread / 2 left hand thread)
4 - E-Flite Blade 350 QX / QX2 / QX3 Spinner Nuts (2 right hand thread / 2 left hand thread)
16 - M2.5 x 4mm socket head screws
Weight (single prop adapter only): 3.1g
(single spinner nut only): 2.6g
Dimensions:
- Shaft Diameter: 6mm
- Shaft Thread: M6x1.0 (2 right hand thread and 2 left hand thread)
- Spinner Nut Thread: M6
- Shaft Length: 15.2mm
- Base Thickness: 5.5mm
Recommended Plastic Prop Sets:
- APC 8x3.8 Slow Flyer - 2 x LP08038SF (standard) / 2 x LP08038SFP (pusher)
- APC 8x4.7 Slow Flyer - 2 x LP08047SF (standard) / 2 x LP08047SFP (pusher)
- APC 8x4.5 Multi Rotor - 2x LP08045MR (standard) / 2x LP08045MRP (pusher) / 1 x Ring Adapter Kit LPAR06E
Must use the 6mm I.D. bushing (ring) to fit properly onto adapters. These will be a snug fit so a little pressure may be needed to slip prop onto shaft.
Recommended Carbon Fiber Prop Set:
-
Red Rocket Hobbies 8x4.5 Carbon Fiber Props. These have a 6mm hole for a perfect fit. Need to purchase 2 sets.
Notes:
DO NOT USE ORIGINAL PROPELLER SCREWS TO ATTACH ADAPTERS. THEY WILL BE TO LONG AND CAN CAUSE DAMAGE TO THE MOTOR.
When replacing props it is recommended to check the current (amp) draw with a watt meter so the motor or ESC amperage rating is not exceeded.
Using aftermarket props with the same diameter and pitch of the original props is recommended if a watt meter is not available.
Adapter screws should be checked and tightened as necessary. A drop of blue (removable) loctite can be applied to the 16 screws before installing the adapter.