Multiplex Easy Glider Pro AXI / E-Flite
Availability: Out Of Stock
| |
 |
The Multiplex Easy Glider Pro AXI / E-Flite series motor mount is CNC machined from billet aluminum. This mount will convert the common 16x19mm mm bolt patterns found on many AXI and E-Flite 35mm outrunner motors to a 25x25mm bolt pattern that can be attached to the cowl of the Easy Glider Pro.
This will allow you to use all 4 screws to properly secure the motor to the cowl with no modifications necessary.
Two step installation:
- Attach new motor to aluminum mount with the motors supplied screws
- Attach entire assembly to the planes firewall / cowling with the original mounting screws
Included: 1 - Multiplex Easy Glider Pro AXI / E-Flite Aluminum Motor Mount
Weight: 3.9g
Thickness: .175" (4.4mm)
Notes:
Motor shaft must be sticking out the back side of the motor (where the wires are) to work properly on the Easy Glider Pro.
If the stock spinner assembly is going to be used, please verify that the collet size is the same size as the motor shaft of the new motor used. Aftermarket spinners can be found in different collet sizes if necessary.
Center of Gravity should always be checked and adjusted per the user manual after any new motor is installed.
Compatible Motors
Here are a few options.
- AXI 2814 Series
- E-Flite Park 480 1020KV (shaft must be pushed through the back)
- E-Flite Park 480 910KV (shaft must be pushed through the back)
- Others with bolt patterns shown below and reversed shaft
Acceptable bolt patterns (units in mm):
- 16x16
- 16x19
- 19x19
Please contact us with any questions on motor compatibility.