Aluminum Prop Adapter Set for Multirotor 4114 Brushless Motors

Each of our Aluminum Prop Adapter Sets are CNC machined from billet aluminum.  These adapters will bolt on to the popular multirotor 4114 sized brushless motors such as those made by Sunnysky, Tarot, Multistar, DJI, IPower and RC-Timer.  Please see our motor compatibility tab for more info on motor choices.

This adapter set will allow a large variety of plastic and carbon fiber propellers to be used giving you the ability to optimize your quad for the best possible performance.

The adapters are very light and strong giving you the confidence needed for worry free flying. 

This set includes 2 right hand thread adapters and 2 left hand thread adapters.  Each propeller will be self tightening while the motor is powered.

Installation is quick and simple with no modifications necessary.
 

Two step installation:

1. Install prop adapter onto motor using the supplied socket head screws.
    
2. Install propeller onto adapter followed by the M6 washer and tighten with the M6 Hex Nut.
   (Or you can use our M6 Spinner / Prop Nut Set)
    

Included:  4 - Multirotor 4114 Prop Adapters (2 right hand thread / 2 left hand thread)
              16 - M3 x 4mm socket head screws
              2 - M6 right hand thread hex nuts, 2 - M6 left hand thread hex nuts, 4 - M6 Flat Washers
 

Weight (single prop adapter only):  3.0g
 

Dimensions:

• Shaft Diameter:  6mm
• Shaft Thread:  M6x1.0  (2 right hand thread and 2 left hand thread)
• Shaft Length:  15.2mm
• Base Thickness:  6.35mm
• Bottom Side Hole:  4mm diameter x 8.5mm deep
• Hole Spacing:  12mm
   

Notes:

When replacing props it is recommended to check the current (amp) draw with a watt meter so the motor or ESC amperage rating is not exceeded.

Adapter screws should be checked and tightened as necessary.  A drop of blue (removable) loctite can be applied to the 16 screws before installing the adapter.

Compatible Motors

• Multistar 4114-320KV
• ​Sunnysky X3108S KV720 and KV900
• Tarot 4114-11 (Requires M2.5 screws.  Will supply upon request)
• DJI S800 4114
• RC Timer 4114-350KV
• IPower 4114-120

For other similar sized motors please verify they have a 4mm shaft and 12mm spaced mounting holes.

Please contact us with any questions 

Write a review